Les articles numériques ne sont pas inclus dans le calcul des frais de port (voir notre page de livraison (s'ouvre dans un nouvel onglet) pour plus d'infos). Les patrons numériques sont disponibles immédiatement après l'achat.
Détails du produit
This necklace is fun to make right from the start! It features a central elongated caliper cable flanked by twisted stitches and columns of dropped stitches.
The pendant part of the necklace is worked from the bottom up. Although it starts off flat for a few rows, it quickly switches to faux knitting in the round. This method of circular knitting is normally
used for fake swatching in the round. This pattern uses it to create the fringe and body of the pendant
at the same time. Just before binding off, designated stitches will be dropped all the way to the cast on edge. Dropping stitches is usually a mistake, but here it adds excitement and beauty to your knitting.
Flat knitting is resumed just before the bindoff. You’ll then cut your knitting to create the side fringes. Stitches are picked up at the upper corners of the pendant to make the i-cord chains. The necklace width, length, and fringe can be as long as short as you like. Includes an optional chart.
- Marque
- Crèateur indèpendents
- Artisanat
- Tricot
- Designer
- BrenJS Knits
- Produit vedette
- Format
- PDF téléchargeable
- Langue
- Anglais
- Notes
- Cable needles are not needed, locking stitch marker is helpful. Use your scrap yarn to make this fun necklace
- Pages
- 9
- Niveau de compétence
- Intermédiaire
- Poids du fil
