Sweater with Asymmetrical Neck in BC Garn Tussah Tweed - 2291BC - Downloadable PDF

Sweater with Asymmetrical Neck in BC Garn Tussah Tweed – Pattern 2291BC by Jytte Slente

This free, downloadable PDF knitting pattern by designer Jytte Slente, published by BC Garn as pattern number 2291BC, provides instructions for a stylish pullover sweater featuring a distinctive asymmetrical neckline. The design is classified as intermediate in difficulty and is worked primarily in the round, making it an engaging project for knitters who are comfortable with circular needles and basic garment shaping. The asymmetrical neck detail gives this otherwise classic sweater a contemporary, fashion-forward edge.

Garment Overview

The pattern produces a close-fitting to relaxed pullover sweater available in three sizes. The finished bust measurements and lengths are as follows:

• Small: 88 cm bust, 63 cm length
• Medium: 93 cm bust, 65 cm length
• Large: 98 cm bust, 67 cm length

The sweater has a clean, minimalist silhouette with the focal point being the asymmetrical neckband, which is worked separately and joined to the left front at the base of the neck opening. This creates an offset, layered neckline effect that sets the design apart from a standard crew or V-neck construction.

Construction Method

The sweater body is worked in the round on a circular needle from the cast-on edge upward. This seamless approach eliminates the need for side seams along the lower body and creates a smooth, even fabric. The construction process involves several distinct stages:

• The body is cast on and worked in the round until the armhole point, approximately 40–42 cm depending on size.
• At the armhole, the work is divided into four separate sections — two back panels and two front panels — each consisting of 48, 51, or 54 stitches depending on size.
• Each section is then worked back and forth in rows, transitioning from circular to flat knitting to shape the upper body and armholes.
• The asymmetrical neckband is cast on separately (18 stitches) and worked in ribbing to match the depth of both the front and back neck. It is then joined to the left front at the base of the neck opening, creating the signature offset neck effect.

Techniques Used

• Knitting in the round – The lower body is worked seamlessly on a long circular needle, a technique that produces an even, consistent fabric and avoids side seams.
• Flat knitting (back and forth) – Used for the upper body sections after dividing at the armhole, allowing for precise shaping of each panel independently.
• Ribbing – Applied at the lower body cast-on edge and for the asymmetrical neckband, providing stretch and a neat, structured finish.
• Dividing and working separate sections – An intermediate technique where the circular work is split into four parts at the armhole, each worked independently to shape the yoke area.
• Joining a separately worked band – The neckband is knitted independently and then seamed to the garment, requiring careful alignment and finishing skills.

Stitches Used

• Stocking stitch (stockinette stitch) – The main body fabric, worked as knit stitches in the round and as knit on right side, purl on wrong side when worked flat. This creates the smooth, classic jersey surface seen on the sweater.
• K2, P2 Rib – A two-by-two ribbing stitch pattern used for the lower body band and the asymmetrical neckband. This stitch alternates two knit stitches with two purl stitches, producing a flexible, elasticated fabric ideal for edges and necklines.

Tension and Gauge

Achieving the correct tension is essential for this pattern, particularly to ensure the finished measurements match the intended sizes. The specified tension is 22 stitches and 30 rows to a 10 cm square, measured over stocking stitch using 3 mm needles. Kn